unisonic technologies co., ltd mpsa56 pnp silicon transistor www.unisonic.com.tw 1 of 4 copyright ? 2010 unisonic technologies co., ltd qw-r201-082.b pnp mpsa56 ? features * collector-emitter voltage: v ceo =80v * collector dissipation: p d =625mw to-92 1 ? ordering information ordering number pin assignment lead free halogen free package 1 2 3 packing mpsa56l-t92-b MPSA56G-T92-B to-92 e b c tape box mpsa56l-t92-k mpsa56g-t92-k to-92 e b c bulk
mpsa56 pnp silicon transistor unisonic technologies co., ltd 2 of 4 www.unisonic.com.tw qw-r201-082.b ? absolute maximum rating (t a =25 , unless otherwise specified) parameter symbol ratings unit collector-base voltage v cbo -80 v collector-emitter voltage v ceo -80 v emitter-base voltage v ebo -4 v collector current - continuous i c -500 ma total device dissipation 625 mw linear derating factor above t a =25 p d 5 mw/ total device dissipation 1500 mw linear derating factor above t c =25 p d 12 mw/ junction temperature t j +125 storage temperature t stg -55 ~ +150 note: absolute maximum ratings are those values beyond which the device could be permanently damaged. absolute maximum ratings are stress ratings only and functional device oper ation is not implied. ? thermal characteristics parameter symbol ratings unit junction to ambient ja 200 junction to case jc 83.3 /w ? electrical characteristics (ta=25 , unless otherwise specified) parameter symbol test conditions min typ max unit off characteristics collector-emitter breakdown voltage (note 1) bv ceo i c =-1.0ma, i b =0 -80 v emitter-base breakdown voltage bv ebo i e =-100 a, ic=0 -4 v collector cutoff current i ceo v ce =-60v, i b =0 -0.1 a collector cutoff current i cbo v cb =-80v, i e =0 -0.1 a on characteristics i c =-10ma, v ce =-1v 100 dc current gain h fe i c =-100ma, v ce =-1v 100 collector-emitter satu ration voltage v ce(sat) i c =-100ma, i b =-10ma -0.25 v base-emitter on voltage v be(on) i c =-100ma, v ce =-1v -1.2 v small-signal characteristics current gain bandwidth product (note 2) f t i c =-100ma, v ce =-1v, f=100mhz 50 mhz note 1. pulse test: pw<=300 s, duty cycle<=2% 2. f t is defined as the frequency at which ihfei extrapolates to unity.
mpsa56 pnp silicon transistor unisonic technologies co., ltd 3 of 4 www.unisonic.com.tw qw-r201-082.b ? typical characteristics current-gain-bandwidth product, f t (mhz) capacitance -0.1 -0.5-1.0 -10 -50 -100 5.0 10 30 100 capacitance, c (pf) reverse voltage, v r (volts) -5.0 t j =25 70 50 7.0 c ibo 20 c obo time, t(ns) active-region safe operating area -1.0 -5.0 -50 -100 -10 -30 -50 -100 -1.0k collector current, i c (ma) collector-emitter voltage, v ce (volts) -10 -700 -300 -20 -500 -200 -70 t a =25 t c =25 1.0s 1 . 0 m s 1 0 0 s current limit thermal limit second breakdown limit dc current gain, h fe ?on? voltages -0.5 -1.0 -5.0 -50 -100 -500 0 -1.0 voltage, v (volts) collector current, i c (ma) -10 -0.2 -0.8 -0.4 -0.6 v be(on) @ v ce =-1.0v v ce(on) @ i c /i b =10 t j =25 v be(sat) @ i c /i b =10
mpsa56 pnp silicon transistor unisonic technologies co., ltd 4 of 4 www.unisonic.com.tw qw-r201-082.b ? typical characteristics(cont.) collector-emitter voltage, v ce (volts) i c = - 5 0 m a i c = - 1 0 0 m a i c = - 2 5 0 m a temperature coefficient, r vb (mv/ ) 1.0 500 50k 100k 0.01 1.0 time, t (ms) 100 0.03 0.07 5.0 0.2 thermal response 0.7 0.5 0.3 0.1 0.05 0.02 10 50 1.0k 10k 5.0k t 2 t 1 p(pk) duty cycle, d=t 1 /t 2 z jc (t)=r(t) jc t j(pk) -t c =p (pk) z jc (t) z ja (t)=r(t) ja t j(pk) -t a =p (pk) z ja (t) d curves apply for power pulsetrain shown read time at t 1 (see an469) d=0.5 0.2 0.1 0 . 0 5 0.02 0.01 single pulse single pulse utc assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all utc products described or contained herein. utc products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. the information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice.
|
